8.2.1 Making settings in products with the HMI
100 or 101 operating panel
• Make all settings with Grundfos GO or Grundfos
GO Link.
8.2.2 Resetting alarms and warnings in products
with the HMI 100 or 101 operating panel
• Reset a fault indication in one of the following
ways:
- Switch off the power supply until the indicator
lights are off.
- Switch the external start and stop input off and
then on again.
- Use Grundfos GO or Grundfos GO Link.
- Use the digital input if you have set it to Alarm
resetting.
32
English (GB)
To Next Page
Loading...
