8.6 Grundfos GO Link
The product is designed for wired or wireless
communication with Grundfos GO Link.
Grundfos GO Link enables you to set functions and
gives you access to status overviews, configuration
and current operating parameters.
Use Grundfos GO Link together with these interfaces:
• Ethernet cable (Only FM310 and FM311)
• Grundfos MI 301 - USB - Wired/wireless (Only
HMI 100, HMI 200 and HMI 300)
• Grundfos PC Tool Link - USB - Wired
1
2
3
GENI - AYB
USB
USB
Ethernet
TM083379
Grundfos GO Link setup
Pos. Description
1
Ethernet cable:
Standard Ethernet cable CAT5/CAT6.
2
Grundfos MI 301:
Separate module enabling radio
communication. Use the module together
with a USB cable to connect to a laptop.
3
Grundfos PC Tool Link:
Separate module enabling wired
connection to the pump. Use the module
together with a USB cable to connect to a
laptop.
8.6.1 Communication
When Grundfos GO Link initiates communication with
the product, it is done using different verification
methods.
Select the interface connected to the pump:
TM083976
8.6.2
Ethernet
Wired connection can take place using an Ethernet
cable connected directly between a laptop and the
RJ45 interface in the pump or via a local network
having both the pump and the laptop connected to
the same network.
To establish a secure connection between the laptop
and the pump, the user will have to go through a
verification process.
Connecting to a pump can either happen by scanning
for a connected product, which can be a direct
Ethernet connection, or the pump is connected to a
local network or a connection via the pump IP
address.
Initiate connection from Grundfos GO Link and follow
onscreen instructions.
8.6.3 Grundfos MI 301
Radio communication can take place at distances up
to 30 metres. The first time Grundfos GO Link
communicates with the product, you enable
communication by pressing the Radio
communication button or OK on the operating
panel. Select either MI301-Direct connect or MI301-
Radio. When communication takes place, the product
is recognized by Grundfos GO Link, and you can
connect using Direct connect or Radio scan without
having to run a verification.
8.6.4
Grundfos PC Tool Link
Wired connection can take place using Grundfos PC
Tool connected to the AYB terminals of the pump.
Since Grundfos GO Link is wired to the pump within a
short distance, no verification is needed. A direct
connection will be established.
46
English (GB)
To Next Page
Loading...
Need help?
General
