Need help?Do you have a question about the Grundfos CRE Series and is the answer not in the manual?
General| Motor Type | Asynchronous |
|---|---|
| Enclosure Class | IP55 |
| Insulation Class | F |
| Series | CRE |
| Protection Class | IP55 |
| Material | Stainless Steel |
| Applications | Water Supply, Pressure Boosting, Irrigation |
| Pumped liquid | Clean liquids |
| Approvals | CE |
| Voltage | 380-415V |
| Connection Size | DN 32 to DN 100 |
| Efficiency | IE3 Premium Efficiency |
| Power Supply | 3-phase |
| Liquid Temperature Range | -10°C to +120°C |
| Temperature Range | -10°C to +120°C |
Identifies potential hazards and safety warnings.
Instructions for securely mounting the pump unit.
Critical safety measures for electrical protection.
Measures to protect against voltage surges.
Details on supplementary protective measures.
Procedure for setting the desired setpoint value.
Selection and explanation of different operating modes.
Selection and configuration of various control modes.
Configuration and wiring of analog input terminals.
Configuration and wiring of digital input terminals.
Recommended controller settings for optimal performance.
Function to monitor parameters and trigger actions when limits are exceeded.
Configuration of the low-flow stop function.
Defines how the pump reacts to sensor failures.
Settings for wired and wireless communication.
Guided setup for motor, sensors, and setpoint configuration.
Setup and configuration for multi-pump systems.
Default settings provided by Grundfos GO.
Procedures for routine maintenance of the product.
Detailed electrical specifications for three-phase motors.
Electrical limits and specifications for all inputs and outputs.
Recommended torque values for terminals and parts.
To Next Page
