Grundfos CRE Series - Page 39

Status Single pump Multipump system
Pump 2, multi-pump system •
Pump 3, multi-pump system •
Pump 4, multi-pump system •
6)
Only available if an advanced functional module, type FM310 or FM311, is fitted.
Settings Single pump Multipump system
Setpoint • •
Operating mode • •
Set manual speed • •
Set user-defined speed • •
Control mode • •
Setting the proportional pressure •
Analog inputs • •
Analog input 1, setup • •
Analog input 2, setup • •
Analog input 3, setup
7)
• •
Built-in Grundfos sensor • •
Pt100/1000 inputs
7)
• •
Pt100/1000 input 1, setup
7)
• •
Pt100/1000 input 2, setup
7)
• •
Digital inputs • •
Digital input 1, setup • •
Digital input 2, setup
7)
• •
Digital inputs/outputs • •
Digital input/output 3, setup • •
Digital input/output 4, setup
7)
• •
Relay outputs • •
Relay output 1 • •
Relay output 2 • •
Analog output
7)
• •
Output signal
7)
• •
Function of analog output
7)
• •
Controller settings • •
Operating range • •
Setpoint influence • •
Ext. setpoint infl. • •
Predefined setpoints
7)
• •
39
English (GB)