Settings With factory-fitted sensor
Without factory-fitted
sensor
Ramps
Ramp-up time: 1 s
Ramp-down time: 3 s
Ramp-up time: 1 s
Ramp-down time: 3 s
Number 1 1
Radio communication Activated Activated
Analog input 1 4-20 mA Not active
Analog input 2 Not active Not active
Analog input 3 Not active Not active
Pt100/1000 input 1 Not active Not active
Pt100/1000 input 2 Not active Not active
Digital input 1 Ext. stop Ext. stop
Digital input 2 Not active Not active
Digital input/output 3 Not active Not active
Digital input/output 4 Not active Not active
Pulse flowmeter (Pulse flowmeter setup) - -
Predefined setpoint 0 bar 0 %
Analog output Speed/0-10 V Speed/0-10 V
External setpoint funct. Not active Not active
Signal relay 1 Alarm Alarm
Signal relay 2 Ready Ready
Limit 1 exceeded Not active Not active
Limit 2 exceeded Not active Not active
LiqTec (LiqTec function) Not active Not active
Detection delay 10 seconds 10 seconds
Standstill heating Not active Not active
Motor bearing monitoring Not active Not active
Pump name - -
Connection code - -
Unit configuration (Units) SI SI
80
English (GB)
To Next Page
Loading...
