English (GB)
17
11.1 Home display
Fig. 21 Example of Home display
11.2 Startup guide
The pump incorporates a startup guide which is
started at the first startup. See section 13.37 Run
start-up guide. After the startup guide, the main
menus appear in the display.
TM06 4516 2415
Pos. Symbol Description
1
Home
This menu shows up to four
user-defined parameters. You
can select parameters shown
as shortcut icon , and when
pressing you go directly to
the "Settings" display for the
selected parameter.
2-
Status
This menu shows the status of
the pump and system as well
as warnings and alarms.
3-
Settings
This menu gives access to all
setting parameters. You can
make detailed settings of the
pump in this menu.
See section 13. Description of
functions.
4-
Assist
This menu enables assisted
pump setup, provides a short
description of the control
modes and offers fault advice.
See section 14. Selection of
control mode.
5
Indicates that the pump has
been stopped via the
button.
6
Indicates that the pump is
functioning as master pump in
a multipump system.
7
Indicates that the pump is
functioning as a slave pump in
a multipump system.
8
Indicates that the pump is
operating in a multipump
system. See section
13.43 "Multipump setup"
(Setup of multi-pump system).
Setpoint
5.00 bar
Operating mode
Normal
Actual controlled value
4.90 bar
Control mode
Const. pressure
Status Settings Assist
1 2 3 4
9
Indicates that the possibility to
make settings has been
disabled for protective reasons.
See section 13.28 "Buttons on
product" (Enable/disable
settings).
Pos. Symbol Description
To Next Page
Loading...
