Grundfos TPE Series - Description of Control Mode; Assisted Fault Advice

English (GB)
53
Disabling the multipump function via Grundfos
GO
1. Select the "Assist" menu.
2. Select "Multipump setup".
3. Select "Disable".
4. Press [>] to continue.
5. Confirm the multipump setup by pressing [Send].
6. Press [Finish].
The multipump function has now been disabled.
Disabling a multipump via advanced control
panel
1. Select the Assist menu.
2. Select Setup of multi-pump system.
3. Press [>] to continue.
4. Confirm No multi-pump function by pressing
[OK].
5. Press [>] to continue.
6. Press [OK].
The multipump system has now been disabled.
13.44 Description of control mode
This menu is only available in the advanced control
panel.
This menu describes each of the possible control
modes. See also section 13.5 "Control mode".
13.45 Assisted fault advice
This menu gives guidance and corrective actions in
case of pump failures.
Pump variant
Description of control
mode
TPE, TPED, NBE,
NBGE, NKE, NKGE
-
TPE, TPED, NBE, NKE
Series 2000
●
Pump variant Assisted fault advice
TPE, TPED, NBE,
NBGE, NKE, NKGE
●
TPE, TPED, NBE, NKE
Series 2000
●