Grundfos TPE Series - Page 24

English (GB)
24
"Settings"
TPE,
TPED,
NBE,
NBGE,
NKE,
NKGE
TPE,
TPED,
NBE,
NKE
Series
2000
Multipump
system
Section Page
"Setpoint" ●● ●13.1 Setpoint 26
"Operating mode" ●● ●13.2 Operating mode 26
"Set user-defined
speed"
●● ●13.4 "Set user-defined speed" 26
"Control mode" ●● ●13.5 "Control mode" 27
"Proportional-pressure
setup"
- ● - 13.6 "Proportional-pressure setup" 32
"Buttons on product" ●● ●
13.28 "Buttons on product"
(Enable/disable settings)
46
"Controller" ●● ●
13.14 "Controller" ("Controller
settings")
38
"Operating range" ●● ●13.15 Operating range 40
"Ramps" ●● 13.19 "Ramps" 44
"Pump number" ●● - 13.23 "Number" (Pump number) 45
"Radio communication" ●● -
13.24 "Radio communication"
(Enable/disable radio comm.)
45
"Analog input 1" ●● -
13.7 Analog inputs 32"Analog input 2" ●● -
"Analog input 3" ●● -
"Built-in Grundfos
sensor"
- ●●
2)
13.8 Built-in Grundfos sensor 33
"Pt100/1000 input 1" ●● -
13.9 Pt100/1000 inputs 33
"Pt100/1000 input 2" ●● -
"Digital input 1" ●● -
13.10 Digital inputs 34
"Digital input 2" ●● -
"Digital in/output 3" ●● -
13.11 Digital inputs/outputs 35
"Digital in/output 4" ●● -
"Predefined setpoint" ●● ●13.16.2 "Predefined setpoints" 42
"Analog output" ●● - 13.13 Analog output 37
"External setpoint funct." ●● - 13.16.2 "Predefined setpoints" 40
"Signal relay 1" ●● -
13.12 "Signal relays 1 and 2"
(Relay outputs)
37
"Signal relay 2" ●● -
"Limit 1 exceeded" ●● ●
13.17 Limit-exceeded function 43
"Limit 2 exceeded" ●● ●
"Alternating operation,
time"
-- ●
1)
13.43 "Multipump setup" (Setup of
multi-pump system)
49
"Time for pump
changeover"
-- ●
1)
"Standstill heating" ●● - 13.20 "Standstill heating" 44
"Motor-bearing
monitoring"
●● - 13.21 Motor bearing monitoring 44
"Service" ●● - 13.22 "Service" 45