User Manual 9065/9065plus
MAN10772-00 37
The following messages appear to indicate other printer conditions or user intervention requests.
The list is in alphabetical order.
MESSAGE DESCRIPTION
ALTERNATE This message appears to indicate that the Alternate functions of the operator panel
keys have been selected pressing the ALTERNATE key.
BUSY M1
This
message
appears
to
indicate
that
the
printer
is
printing.
It
is
busy
COVER OPEN
CLOSE COVER
When the printer cover is not closed correctly, the buzzer sounds and the display
shows alternately these two messages. Close the printer cover
INITIALIZING LAN This message is displayed when the LAN is reset (only if the LAN interface is
present)
INVALID KEY This message is displayed if you push a key that is not allowed in the current printer
status
LOAD FRONT1
LOAD FRON2
These messages are displayed when the corresponding paper path is out of
paper. The printer displays only the messages related to the installed devices
LOCKED MENU When the access to the Printer Setups has been locked at the power on, the printer
displays this message
MACRO CHANGING The macro has been changed and the printer is updating the settings
MICRO FEED DOWN The paper is fed in microsteps downwards when pressing the ↓ arrow key
MICRON FEED UP The paper is fed in microsteps upwards when pressing the ↑ arrow key
OPER.INTERRUPTED This message is displayed if the ALTERNATE key has been pressed to interrupt a
park procedure
PARKING The printer is parking the fanfold paper
PARK PAPER
TEAR IS NECESSARY
The parking action is run with the message for operator to tear the printed paper
PARK PAPER
TEAR OFF PAPER
The parking action is already run but the paper remain in the printer path because
too long (maximum paper length for automatic parking is 28” (711,2mm). The
operator is advise to tear paper.
PATH CHANGING The path has been changed and the printer is updating the settings
PRESS A KEY
NVM CHANGED
The NVM has been changed. Press any key to set the printer.
This message appears when the FW is updated.
RELEASE KEYS This message is displayed when you can release the ON LINE key in the Self-test
selection or the PROGRAM key in the Power-on Configuration procedure
REMOTE CONTROL This message is displayed when the printer operates from remote control (only if the
LAN interface is present).
RESET & BREAK This message is displayed when the input buffer corresponding to the active
interface is cleared
SELF TEST Printing the self-test page.
STARTING UP The starting-up phase after power on is running
TEAR IF NECESS.
EJECT PAPER
These messages are displayed when the printer receives a paper parking
command and the TEAR NO item is selected for the tear-off function. Tear off the
fanfold then press the PARK key to eject the paper
TEAR IF NECESS.
PARK PAPER
These messages are displayed when the printer receives a paper parking
command. Tear off the fanfold paper if necessary and then press the PARK key to
park the paper
UNLOCKED MENU When the access to the Printer Setups has been unlocked at the power on, the
printer displays this message
WAITING CODE The special function to download a new FW Release is running
UNLOCKED MENU When the access to the Printer Setups has been unlocked at the power on, the
printer displays this message
For the error messages see "Error Handling” later in this manual
To Next Page
Loading...