User Manual 9065/9065plus
MAN10772-00 86
Superscript/Subscript Character Enable
8 BIT CTRL YES
↑
S/SUB SCRIPT YES
→
or
←
S/SUB SCRIPT NO
→
or
←
↓
ESC+CTR CODE YES
The printer will (YES) or will not (NO) respond to ESC [2 m and ESC [3 m commands.
ESC+Control Code
S/SUB SCRIPT YES
↑
ESC+ CTR CODE YES
→
or
←
ESC+ CTR CODE NO
→
or
←
↓
VT NOT SET YES
In this setting the control codes embedded within escape sequence are valid (YES) or ignored (NO). In both cases,
the escape sequence will be valid.
VT Code
ESC+ CTR CODE YES
↑
VT NOT SET YES
→
or
←
VT NOT SET NO
→
or
←
↓
DOUBLE LF YES
In this setting the VT code received without tab set will yield line feed (YES) or will be ignored (NO).
Double Line Feed
VT NOT SET YES
↑
DOUBLE LF YES
→
or
←
DOUBLE LF NO
→
or
←
↓
DOUBLE LF YES
If the printer receives a command (LF) from the host to execute a line feed, then the printer will (Y) or will not (N)
also perform double line feed based upon your selection.
To Next Page
Loading...