Model 675 User Instructions 25
2.3 F3 - GSE Default
If the preprogrammed applications are not going to be used, than the Model 675 should
be factory defaulted. This mode will reset the Model 675 to GSE factory default status.
Note: The preset applications will be lost.
The Model 675 can still be used as a parts counter after it is factory defaulted. Refer to
page 31 for more details on simple counting.
1. Press [F3] from the Application Menu prompt. The display will give an
explanation of the GSE DEFAULT.
2. Press [ENTER] (YES) to accept the choice of GSE DEFAULT and continue or
press [CLR] to cancel the default and return to the Application Menu.
3. If you chose to continue with the default in step 2 the display will ask ARE YOU
SURE? Press [ENTER] (YES) to default the unit or press [CLR] to cancel the
default and return to the Application Menu.
To Next Page
Loading...
