GSE 675 - Sample and Count Procedure

28 Model 675 User Instructions
2a. Press the [F1] Sample or [SAMPLE] key without the sample pieces on the
scale. The scale will perform a tare to establish a net zero reference.
3. Add the sample pieces and press the [F1] Accept key to accept the sample.
4. Continue to add pieces to count
Without Auto Tare
1. If the sample size is known and a container is used:
1a. Place an empty container on the scale and press [TARE] key.
1b. Place the sample in the container.
1c. Key in the sample size and then press the [F1] Sample or [SAMPLE] key. The
scale will accept the current weights as a sample and will display the quantity.
2. If the sample size is known and no container is used:
2a. Place the sample on the scale.
2b. Key in the sample size and then press the [F1] Sample or [SAMPLE] key. The
scale will accept the current weights as a sample and will display the quantity.
Use the [SELECT] key to check other modes such as the Tare weight and Average
Piece Weight. The [F2] (Count) can be pressed to return to the count mode at any
time.
0 000 .
Add
10
10
Qty
89
Qty
50
Qty