23
# Configure the SSID as China-net.
[AP-WLAN-Radio2/0] client-mode ssid China-net
# Connect the AP to the wireless network.
[AP-WLAN-Radio2/0] client-mode connect
[AP-WLAN-Radio2/0] return
Verifying the configuration
Use the display wlan client-mode radio command to display the configuration and connection
status for the workgroup bridge.
<AP> display wlan client-mode radio
WLAN Client Mode
--------------------------------------------------------------------------------
Radio : 1
Mode : 802.11g
Authentication Method : Shared-Key
Cipher Suite : WEP40
Key (Simple) : 12345
WEP Key ID : 1
SSID : China-net
BSSID : 000f-e233-5501
Status : Connected
--------------------------------------------------------------------------------
Received Packets
Data : 1324939
Management : 34876
Sent Packets
Data : 46365
Discarded Packets : 38272
Rate(Rx/Tx) : 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15
Online Duration : 0 days 0 hours 45 minutes 5 seconds
--------------------------------------------------------------------------------
The output shows that the AP that operates as a workgroup bridge has been successfully associated
with wireless service China-net.
Configuration guidelines
• As shown in Figure 10, the workgroup bridge has two radio interfaces. Radio 1 connects the
workgroup bridge to the AP, and Radio 2 connects the workgroup bridge to the client. To enable
the client associated with Radio 2 to access the AP through the workgroup bridge, you need to
disable wireless user isolation by performing the wlan-client-isolation enable command on
the workgroup bridge.
Figure 10 Workgroup bridge with two radio interfaces
AP
Workgroup Bridge
Client
Radio 1
Radio 2
To Next Page
Loading...
Need help?
General
