H3C MSR Series Configuration Guide

61
[AP-wlan-st-1] ssid service
[AP-wlan-st-1] authentication-method open-system
[AP-wlan-st-1] service-template enable
[AP-wlan-st-1] quit
# Bind WLAN-Radio 2/0 to service template 1 and WLAN-BSS 1.
[AP] interface Wlan-radio 2/0
[AP-Wlan-radio2/0] service-template 1 interface WLAN-BSS 1
[AP-Wlan-radio2/0] quit
# Configure the AP to operate in hybrid mode. It scans rogue devices and provides access services.
[AP] wlan device-detection enable
Blacklist and whitelist configuration example
Network requirements
As shown in Figure 27, to ensure WLAN security, add the MAC address of the client into the blacklist
on the AC to disable it from accessing the wireless network through any AP.
Figure 27 Network diagram
Configuration procedure
# Add MAC address 0000-000f-1211 of Client 1 into the blacklist.
<Sysname> system-view
[Sysname] wlan ids
[Sysname-wlan-ids] static-blacklist mac-address 0000-000f-1211
After the configuration, Client 1 cannot access the AP, and other clients can access the network.

H3C MSR Series Specifications

General

Category	Network Router
IPv6 Support	Yes
Dimensions	Varies by model
Weight	Varies by model
Product Type	Modular Router
Ports	Varies by model
WAN Interfaces	Varies by model
Firewall	Yes
QoS	Yes
Wireless Support	Varies by model
USB Ports	Varies by model
Console Port	Yes
Power Supply	Varies by model
Redundancy	Varies by model
Operating Temperature	0°C to 45°C
Storage Temperature	-40°C to 70°C
Humidity	5% to 95% non-condensing
Series	MSR
Certifications	CE, FCC, RoHS