49
The S5560X-30C-EI switch comes with the two fan tray slots empty. You must install two fan trays of
the same model for the switch. In this figure, two LSPM1FANSB fan trays are installed in the fan tray
slots. For more information about installing and removing a fan tray, see "Installing/removing a fan
tray."
The S556
0X-30C-EI switch comes with a filler panel in the expansion slot. You can select an
expansion card for the switch as required. In this figure, an LSWM2SP2PM interface card is installed
in the expansion slot. For more information about installing and removing an expansion card, see
"Installing/removing an expansion card."
S5560X-30C-PWR-EI
Figure 55 Front panel
(1) 10/100/1000BASE-T autosensing Ethernet port
(2) 10/100/1000BASE-T autosensing Ethernet port LED
(3) Management Ethernet port (4) Console port (CONSOLE)
(5) Micro USB console port (6) Mode button
(7) USB port (8) System status LED (SYS)
(9) SFP+ port (10) Mode LED (MODE)
(11) Expansion card status LED (SLOT) (12) Power module 2 status LED (PWR2)
(13) Power module 1 status LED (PWR1) (14) SFP+ port LED
(15) Management Ethernet port LED (ACT/LINK)
Figure 56 Rear panel
(1) Grounding screw (2) Fan tray 1
(3) Expansion card (4) Fan tray 2
(5) Power module 1 (6) Power module 2
The S5560X-30C-PWR-EI switch comes with power module slot 1 empty and power module slot 2
installed with a filler panel. You can install one or two power modules for the switch as required. In
this figure, two PSR720-56A AC power modules are installed in the power module slots. For more
information about installing and removing a power module, see "Installing/removing a power
module."
1
14
13
12
11
10
9
8
2
3 4 5 6
7
15
To Next Page
Loading...
Need help?
General