54
Figure 76 S6850-2C rear panel
(1) Mini USB console port (2) Copper management Ethernet port
(3) Serial console port (4) USB port
(5) QSFP28 port (6) Serial label pull tab
(7) Fan tray 1 (8) Fan tray 2
(9) Fan tray 3 (10) Fan tray 4
(11) Fan tray 5 (12) Power module 1
(13) Power module 2 (14) QSFP28 port LED
(15) Fiber management Ethernet port LED (LINK/ACT)
(16) Fiber management Ethernet port (17) Copper management Ethernet port LED (ACT)
(18) System status LED (SYS) (19) Copper management Ethernet port LED (LINK)
The ESN serial number and MAC address of the S6850-2C switch can be found on the serial label
pull tab.
The S6850-2C switch comes with expansion slot 1 empty and expansion slot 2 installed with a filler
panel. You can install one or two expansion modules for the switch as needed. In Figure 75, two
LSWM1
8CQ interface modules are installed in the expansion slots.
The S6850-2C switch comes with power module slot PWR1 empty and power module slot PWR2
installed with a filler panel. You can install one or two power modules for the switch as needed.
In Figure 76, two LSVM1A
C650 power modules are installed in the power module slots.
The S6850-2C switch comes with the five fan tray slots empty. You must install five fan trays of the
same model for the switch. In Figure 76,
five LSWM1FANSA fan trays are installed in the fan tray
slots.
Figure 77 S6850-2C left panel
(1) Fan tray handle (2) Primary grounding point
(3) Auxiliary grounding point (4) Power module handle
To Next Page
Loading...
Need help?
General