H3C WA Series Command Reference

12-33
View
Interface view
Default Level
2: System level
Parameters
number: Maximum number of neighbors that can be dynamically learned by an interface, which is in the
range of 1 to 256 and defaults to 256.
Description
Use the ipv6 neighbors max-learning-num command to configure the maximum number of neighbors
that can be dynamically learned on a specified interface.
Use the undo ipv6 neighbors max-learning-num command to restore the default.
Examples
# Set the maximum number of neighbors that can be dynamically learned on VLAN-interface 100 to 10.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] ipv6 neighbors max-learning-num 10
ipv6 pathmtu
Syntax
ipv6 pathmtu ipv6-address [ value ]
undo ipv6 pathmtu ipv6-address
View
System view
Default Level
2: System level
Parameters
ipv6-address: Specified IPv6 address.
value: PMTU of a specified IPv6 address in bytes, in the range of 1280 to 10000.
Description
Use the ipv6 pathmtu command to configure a static PMTU for a specified IPv6 address.
Use the undo ipv6 pathmtu command to remove the PMTU configuration for a specified IPv6 address.
By default, no static PMTU is configured.
Examples
# Configure a static PMTU for a specified IPv6 address.
<Sysname> system-view
[Sysname] ipv6 pathmtu fe80::12 1300

H3C WA Series Specifications

General

Brand	H3C
Model	WA Series
Category	Wireless Access Point
Language	English