H3C WA Series Command Reference

12-28
Examples
# Enable the consistency check on the source MAC address of ND packets.
<Sysname> system-view
[Sysname] ipv6 nd mac-check enable
ipv6 nd ns retrans-timer
Syntax
ipv6 nd ns retrans-timer value
undo ipv6 nd ns retrans-timer
View
Interface view
Default Level
2: System level
Parameters
value: Interval for sending NS messages in milliseconds, in the range of 1,000 to 4,294,967,295.
Description
Use the ipv6 nd ns retrans-timer command to set the interval for sending NS messages. The local
interface sends NS messages at intervals of this value. Furthermore, the Retrans Timer field in RA
messages sent by the local interface is equal to this value.
Use the undo ipv6 nd ns retrans-timer command to restore the default interval.
By default, the local interface sends NS messages at intervals of 1,000 milliseconds and the Retrans
Timer field in RA messages sent by the local interface is 0.
Related commands: display ipv6 interface.
Examples
# Specify VLAN-interface 100 to send NS messages at intervals of 10,000 milliseconds.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] ipv6 nd ns retrans-timer 10000
ipv6 nd nud reachable-time
Syntax
ipv6 nd nud reachable-time value
undo ipv6 nd nud reachable-time
View
Interface view
Default Level
2: System level
Parameters
value: Neighbor reachable time in milliseconds, in the range of 1 to 3,600,000.

H3C WA Series Specifications

General

Brand	H3C
Model	WA Series
Category	Wireless Access Point
Language	English