H3C WA Series Command Reference

10-12
Default Level
1: Monitor level
Parameters
None
Description
Use the display udp statistics command to display statistics of UDP packets.
Related commands: reset udp statistics.
Examples
# Display statistics of UDP packets.
<Sysname> display udp statistics
Received packets:
Total: 0
checksum error: 0
shorter than header: 0, data length larger than packet: 0
unicast(no socket on port): 0
broadcast/multicast(no socket on port): 0
not delivered, input socket full: 0
input packets missing pcb cache: 0
Sent packets:
Total: 0
Table 10-7 display udp statistics command output description
Field Description
Total Total number of UDP packets received
checksum error Total number of packets with incorrect checksum
shorter than header Number of packets with data shorter than head
data length larger than packet Number of packets with data longer than packet
unicast(no socket on port) Number of unicast packets with no socket on port
broadcast/multicast(no socket on
port)
Number of broadcast/multicast packets without socket on
port
not delivered, input socket full
Number of packets not delivered to upper layer due to
socket buffer being full
Received
packets:
input packets missing pcb cache
Number of packets without matching protocol control
block (PCB) cache
Sent
packets:
Total Total number of UDP packets sent
ip redirects enable
Syntax
ip redirects enable
undo ip redirects

H3C WA Series Specifications

General

Brand	H3C
Model	WA Series
Category	Wireless Access Point
Language	English