H3C WA Series Command Reference

10-3
Description
Use the display fib ip-address command to display FIB entries that match the specified destination IP
address.
If no mask or mask length is specified, the FIB entry that matches the destination IP address and has
the longest mask will be displayed; if the mask is specified, the FIB entry that exactly matches the
specified destination IP address will be displayed.
Examples
# Display the FIB entries that match the destination IP address of 10.2.1.1.
<Sysname> display fib 10.2.1.1
Destination count: 1 FIB entry count: 1
Flag:
U:Useable G:Gateway H:Host B:Blackhole D:Dynamic S:Static
R:Relay
Destination/Mask Nexthop Flag OutInterface InnerLabel Token
10.2.1.1/32 127.0.0.1 UH InLoop0 Null Invalid
For description about the output, see Table 10-1.
display icmp statistics
Syntax
display icmp statistics
View
Any view
Default Level
1: Monitor level
Parameters
None
Description
Use the display icmp statistics command to display ICMP statistics.
Related commands: display ip interface (IP Addressing in the Layer 3 – IP Services Command
Reference), reset ip statistics (IP Performance Optimization in the Layer 3 – IP Services Command
Reference).
Examples
# Display ICMP statistics.
<Sysname> display icmp statistics
Input: bad formats 0 bad checksum 0
echo 5 destination unreachable 0
source quench 0 redirects 0
echo reply 10 parameter problem 0
timestamp 0 information request 0
mask requests 0 mask replies 0
time exceeded 0
Output:echo 10 destination unreachable 0
source quench 0 redirects 0

H3C WA Series Specifications

General

Brand	H3C
Model	WA Series
Category	Wireless Access Point
Language	English