5-4
IP address is available, the server assigns the client an IP address from the specified extended
address pool.
z Only an extended address pool can be applied on an interface. The address pool to be referenced
must already exist.
Related commands: dhcp server ip-pool.
Examples
# Apply extended DHCP address pool VLAN 1 on VLAN-interface 1.
<system> system-view
[Sysname] interface vlan-interface 1
[Sysname-Vlan-interface1] dhcp server apply ip-pool VLAN1
dhcp select server global-pool
Syntax
dhcp select server global-pool [ subaddress ]
undo dhcp select server global-pool [ subaddress ]
View
Interface view
Default Level
2: System level
Parameters
subaddress: Supports subaddress allocation. That is, the DHCP server and clients are on the same
network segment, and the server allocates IP addresses from the address pool containing the network
segment of the first subaddress if several subaddresses exist.
Description
Use the dhcp select server global-pool command to enable the DHCP server on specified
interface(s). After the interface receives a DHCP request, the DHCP server will allocate an IP address
from the address pool.
Use the undo dhcp select server global-pool command to remove the configuration. That is, upon
receiving a DHCP request from a client, the interface will not assign an IP address to the client.
Use the undo dhcp select server global-pool subaddress command to cancel the support for
subaddress allocation.
By default, the DHCP server is enabled on an interface.
Examples
# Enable the DHCP server on VLAN-interface 1.
<Sysname> system-view
[Sysname] interface vlan-interface 1
[Sysname-Vlan-interface1] dhcp select server global-pool
dhcp server detect
Syntax
dhcp server detect
To Next Page
Loading...
Need help?
General
