H3C WA Series

To Next Page

To Previous Page

12-25

Use the undo ipv6 mtu command to restore the default MTU.

By default, the MTU value is 1500 bytes.

Examples

# Set the MTU of IPv6 packets sent over VLAN-interface 100 to 1280 bytes.

<Sysname> system-view

[Sysname] interface vlan-interface 100

[Sysname-Vlan-interface100] ipv6 mtu 1280

ipv6 nd autoconfig managed-address-flag

Syntax

ipv6 nd autoconfig managed-address-flag

undo ipv6 nd autoconfig managed-address-flag

View

Interface view

Default Level

2: System level

Parameters

None

Description

Use the ipv6 nd autoconfig managed-address-flag command to set the managed address

configuration (M) flag to 1 so that the host can acquire an IPv6 address through stateful

autoconfiguration (for example, DHCP server).

Use the undo ipv6 nd autoconfig managed-address-flag command to restore the default.

By default, the M flag is set to 0 so that the host can acquire an IPv6 address through stateless

autoconfiguration.

Examples

# Configure the host to acquire an IPv6 address through stateful autoconfiguration.

<Sysname> system-view

[Sysname] interface vlan-interface 100

[Sysname-Vlan-interface100] ipv6 nd autoconfig managed-address-flag

ipv6 nd autoconfig other-flag