H3C WA Series Command Reference

12-4
InTooShorts: 0
InTruncatedPkts: 0
InHopLimitExceeds: 0
InBadHeaders: 0
InBadOptions: 0
ReasmReqds: 0
ReasmOKs: 0
InFragDrops: 0
InFragTimeouts: 0
OutFragFails: 0
InUnknownProtos: 0
InDelivers: 0
OutRequests: 4
OutForwDatagrams: 0
InNoRoutes: 0
InTooBigErrors: 0
OutFragOKs: 0
OutFragCreates: 0
InMcastPkts: 0
InMcastNotMembers: 0
OutMcastPkts: 4
InAddrErrors: 0
InDiscards: 0
OutDiscards: 0
Table 12-2 display ipv6 interface command output description
Field Description
Vlan-interface2 current state
Physical state of the interface:
z Administratively DOWN: Indicates that the VLAN interface is
administratively down; that is, the interface is shut down using the
shutdown command.
z DOWN: Indicates that the VLAN interface is administratively up but
its physical state is down; that is, no ports in the VLAN are up,
which may be caused by a connection or link failure.
z UP: Indicates that the administrative and physical states of the
VLAN interface are both up.
Line protocol current state
Link layer protocol state of the interface:
z DOWN: Indicates that the link layer protocol state of the VLAN
interface is down, generally because no IP address is configured.
z UP: Indicates that the link layer protocol state of the VLAN interface
is up.
IPv6 is enabled
IPv6 packet forwarding state of the interface (after an IPv6 address is
configured for an interface, IPv6 is automatically enabled on it; IPv6
packet forwarding is enabled in the example)
link-local address Link-local address configured for the interface
Global unicast address(es) Aggregatable global unicast address(es) configured for the interface
valid lifetime Valid lifetime of the global unicast address
preferred lifetime Preferred lifetime of the global unicast address
Joined group address(es) Address(es) of multicast group(s) that the interface has joined
MTU Maximum transmission unit of the interface

H3C WA Series Specifications

General

Brand	H3C
Model	WA Series
Category	Wireless Access Point
Language	English