PROGRAMMING
96-8000
140
June 1999
The mirror function can change the direction of motion along any of the axes. If any one of these are selected,
the display will show the status. Mirror image will reflect programmed motion around your work coordinate zero
point. Be careful that mirror of only one of X or Y will cause the cutter to move along the opposite side of a cut.
In addition, if mirror is selected for only one axis of a circular motion plane, circular motion G02 and G03 are
reversed and left side and right side cutter compensation G41 and G42 are reversed. Settings 45 through 48 are
used to select mirror image.
See the sections on G52, G92, and Setting 33 for more on work coordinate systems.
Offsets can be sent and received with the RS-232 port. See the "Data Input / Output" section for information on
how to do this.
To Next Page
Loading...
Need help?
General
