418
OPTIONS
96-8000
June 1999
INSTALLATION
TOOLS REQUIRED:
• Machinists' level (2) • Forklift capable of lifting 5,000 lbs, with forks at least 6' long
• 6' straight-edge • Included - APC chain rotation tool (P/N 20-0102)
• Allen wrenches • Included - APC jumper
Prior to installing your VMC, make certain that there is enough floor space on the right-hand side of the VMC to
place the APC. The APC will add approximately 52
1
/
2
" (57
1
/
2
" for the VF-4) to the width of the VMC. Ensure
that all the air and power requirements for the VMC have been met.
Note: After unpacking the APC remove the pallet fixing bolts and take the pallets
down from the top of the APC. Do not reinstall the pallets onto the APC until
it has been properly attached to the VMC and leveled.
CAUTION! The pallets have wipers on the bottom of the clamp rails at the VMC end.
These wipers should overhang any temporary storage postion.
M CODES - INSTALLATION
The following M codes are used during the APC Installation procedure. These M codes are not intended to be
used to program the APC at any other time.
M14 Go to pallet #1 load position
M15 Go to pallet #2 load position
M17 Unclamp pallet and open automatic door
M18 Clamp pallet and close automatic door
CAUTION! When comanding M Codes, always command M17 to open the door before
commanding M14 or M15 to position the table to a pallet load/unload
position. With a pallet present on the receiver the pallet drive leg will interfere
with door movement.
To Next Page
Loading...
Need help?
General
