Operating Environment
50081_Assembly.fm Page 15
2.2 Instrument Assembly
Perform the assembly procedures in this section and then complete the steps in Section 3 on
page 23 to enter basic user information in preparation for performing analyses to comply with
Good Laboratory Practices (GLP). Refer to Section 4 on page 33 for the software setup
required prior to performing analyses. The software setup in Section 4 must be completed
before any analyses can be performed.
2.2.1 Attaching the Titrant Bottle Holder
2.2.2 Connecting the Electrode Head and Accessories
1. Slide the titrant bottle holder into the mounting slot located on the
bottom of the instrument housing.
2. Affix holder into position by compressing the bottle holder slightly and
inserting the tip into the hole located under the rim of the instrument
housing.
Note: Never pick up or carry the titrator by the bottle holder.
1. Thread the support rod onto the threaded stud of the stirrer platform.
Note: Never pick up or carry the titrator by the support rod.
To Next Page
Loading...
