Hach AutoCAT 9000 - Software Setup for Disconnecting or Replacing Electrodes

Software Setup
Software Setup
50081_SoftwareSetup.fm Page 35
4.2.1 Software Setup for Disconnecting or Replacing Electrodes
To disconnect the temperature sensor and electrode:
1. Press
2 to select Disconnect Electrode.
2. Confirm by pressing the
CHECK MARK (for each probe).
3. Remove the probes.
To replace the temperature sensor and/or electrode:
1. Press 3 to select Replace Electrode.
2. Highlight ID, press the
CHECK MARK to confirm.
3. Highlight either 50086-00 (electrode), or 50087-00 (temperature sensor).
4. Press the
CHECK MARK to validate.
5. Press
1 to confirm.
6. Remove the probe.
7. Install the replacement probe.
8. Input the serial number of the replacement probe.
9. Press
1 to confirm.
5. Press 1 to select confirm
and proceed to temperature
sensor installation.
6. Highlight S/N.
Press the
CHECK MARK to
input or change.
7. Use the alphanumeric
keypad to input the last
10 digits of the sensor serial
number (located on the
electrode cable).
Press the
CHECK MARK to
validate.
8. Press 1 to select
Confirm and complete the
installation and return to the
Electrodes menu.
Proceed to Software Setup
for Burette Installation on
page 36.