Hach AutoCAT 9000 - 4.3 Software Setup for Burette Installation

Software Setup
Software Setup
Page 34
50081_SoftwareSetup.fm
5. Press the CHECK MARK
to change the
Return In Mode.
6. Highlight Supervisor.
Press the
CHECK MARK to
validate.
7. Press 1 to select
Confirm Mode.
8. The AutoCAT is now
operating in Supervisor
mode. The Methods menu
will be displayed. Proceed
to Software Setup for
Electrode and Temperature
Sensor Installation.
1. From the Methods
menu (see How to Access
the Menus on page 24), use
the
RIGHT and LEFT keys to
tab to the Electrodes menu.
2. Press 1 to select
Connect Electrodes.
3. Highlight S/N.
Press the
CHECK MARK to
input or change.
4. Use the alphanumeric
keypad to input the last
10 digits of the electrode
serial number (located on
the electrode cable).
Press the
CHECK MARK to
validate.
4.2 Software Setup for Electrode and Temperature Sensor Installation