Page 18 50081_Assembly.fm
Operating Environment
2.2.5 Connecting the Temperature Sensor
3. Place the burette on the burette stand in position A then slide the
burette from position A to position B.
Note: Inspect the alignment of the
piston with the plunger shaft.
Ensure that they are properly
engaged as displayed in the
illustration to the right.
4. Turn the burette ¼-turn clockwise to engage the locking tabs with the
burette stand and lock the burette into position.
5. Thread the connectors of the remaining section of tubing into the top
of the burette and into the corresponding receptacle on the
rotating valve.
Note: Ensure that the tubing is connected to the correct point on the rotating
valve as indicated by the “burette” icon.
1. Remove the protective cap from the temperature sensor.
2. Insert the temperature sensor into a remaining small hole on the
electrode head.
3. Turn the sensor ¼-turn clockwise to lock the collar in place.
4. Connect the cable to the CINCH connector on the back of the
instrument (see Figure 3 on page 19).
To Next Page
Loading...
