Hach AutoCAT 9000 - 4.4 Software Setup for Titrant Installation

Software Setup
Software Setup
Page 36
50081_SoftwareSetup.fm
1. Use navigation keys to
tab to the Titrants menu.
2. Press 6 to select
Burette Functions.
3. Press 5 to select
Install Burette.
4. The burette will
automatically move to the
install position.
5. Highlight
Burette Volume. Press the
CHECK MARK to input or
change.
6. Highlight the desired
burette.
Note: The default software
setting is 5-mL.
Press the CHECK MARK to
validate.
7. Highlight S/N. Press the
CHECK MARK to input or
change.
8. Use the alphanumeric
keypad to input the burette
serial number (located on
the bottom edge of the
burette).
Press the
CHECK MARK to
validate.
4.3 Software Setup for Burette Installation