EB+ Soft Docking Installation guide
20
Innovative Vehicle Solutions 2020
Sensor adjustment
If you cannot position the sensor assembly on the
outermost area of the rear panel, you can adjust the
angular detection of the sensors by using the sensor
notches.
To adjust sensor, press firmly on the centre of the
sensor and click onto the next notch, hence changing
the angle of the sensor
Available settings :
› Vertical : ± 12°
› Horizontal : ± 36°
The sensor angle can be adjusted by 6° increments by
pressing in directions as shown until the sensor clicks
into position.
1 x 6°
1 x 6°
3 x 6°3 x 6°
Drain hole
Refer to customer drawing for sensor adjustment and bandwidth
To Next Page
Loading...
