Wireless Access Point HNW300APN
User Manual 101
11. LAN Interface
This chapter is to configure the parameters for local area network which connects to the LAN port of your
Access Point. Here you may change the setting for IP address, subnet mask, DHCP, etc...
Note: You should only change the addressing details if your ISP asks you to, or if you are familiar with
network configuration. In most cases, you will not need to make any changes to this configuration.
11.1 LAN Interface Setup
To check the configuration of LAN Interface:
1. From the left-hand Network Settings -> LAN Interface menu. The following page is displayed:
To Next Page
Loading...