Wireless Access Point HNW300APN
User Manual 113
12.3 Configuring PPPoE connection
If your ISP’s Internet service uses PPPoE you need to set up a PPP login account. The first time that you
login to the Internet, your ISP will ask you to enter a username and password so they can check that you
are a legitimate, registered Internet service user. Your device stores these authentication details, so you will
not have to enter this username and password every time you login.
If your ISP wants you to connect to the Internet using PPP, follow the instructions below.
1. From the left-hand Network Settings -> WAN Interface menu. The following page is displayed:
2. From the WAN Access Type drop-down list, select PPPoE setting.
3. Enter User Name/Password provided by your ISP. Type them in the relevant boxes.
4. Click Apply Changes.
5. Click OK.
To Next Page
Loading...