Hamlet 300 User Manual

Wireless Access Point HNW300APN
User Manual 153
28.3 Resetting to Defaults
If you do make changes to the default configuration but then wish to revert back to the original factory
configuration, you can do so by resetting the device to factory defaults.
Note: If you reset your device to factory defaults, all previous configuration changes that you have made are
overwritten by the factory default configuration
Software Reset:
1. From the left-hand Management menu, click on Reset factory default. The following page is displayed:
Figure 6: Reset to Defaults page
2. Click on Reset Settings to Default.
3. This page reminds you that resetting to factory defaults cannot be undone – any changes that you have
made to the basic settings will be replaced. If you are happy with this, click OK. Or click Cancel to
cancel it.
4. Reload setting successfully! Please wait for a moment while rebooting ...

Hamlet 300 Specifications

General

Brand	Hamlet
Model	300
Category	Wireless Access Point
Language	English