Hamlet 300 User Manual

Wireless Access Point HNW300APN
User Manual 26
Wireless ISP
In this mode, all Ethernet ports are bridged together and the wireless client will connect to ISP access point.
The NAT is enabled and PCs in Ethernet ports share the same IP to ISP through wireless LAN. You must
set the wireless to client mode first and connect to the ISP AP in Site-Survey page. The connection type can
be setup in WAN page by using PPPOE, DHCP client or static IP.
To change the Operation Mode:
1. From the left-hand menu, click on Quick Setup. The following page is displayed:
2. Click on the ratio of Wireless ISP and then click on Next>>.

Hamlet 300 Specifications

General

Brand	Hamlet
Model	300
Category	Wireless Access Point
Language	English