Hamlet 300 - Page 33

Wireless Access Point HNW300APN
User Manual 33
AP (Access Point)
Access Point is used to configure the parameters for wireless LAN clients who may connect to your Access
Point.
1. From the Band drop-down list, select a Band.
2. From the Mode drop-down list, select AP setting.
3. Enter SSID for example 11n_AP_Router.
4. From the Channel Width drop-down list, select a Channel Width.
5. From the ControlSideband drop-down list, select a ControlSideband.
6. From the Channel Number drop-down list, select a Channel Number.
7. Click Next>>.