Wireless Access Point HNW300APN
User Manual 40
AP (Access Point) + MESH
Access Point is used to configure the parameters for wireless LAN clients which may connect to your
Access Point.
1. From the Band drop-down list, select a Band.
2. From the Mode drop-down list, select AP+MESH setting.
3. Enter SSID for example 11n_AP_Router.
4. From the Channel Width drop-down list, select a Channel Width.
5. From the ControlSideband drop-down list, select a ControlSideband.
6. From the Channel Number drop-down list, select a Channel Number.
7. Click Next>>.
To Next Page
Loading...