Hamlet 300 - Page 86

To Next Page

To Previous Page

Wireless Access Point HNW300APN

User Manual 86

Wireless Advanced Settings page

Users need to make sure the “Broadcast SSID” file is set to “Enabled”. Otherwise, it might prevent WPS

from working properly.

Main Page

Default Chapter2
- Table of Contents2
1 Introduction6
- System Requirements6
- Package Contents6
2 Specification7
- LED Meaning7
- Connectors8
3 Installation & Setup9
- Connection of Access Point9
4 Configuration Procedures10
- Windows 98SE/ME/2000/XP10
- Windows Vista 32/6412
- Windows 7 32/6415
5 Access Point Configuration17
6 Connect Wirelessly21
7 Web Configuration23
- Accessing the Web Interface23
8 Quick Setup24
- Operation Mode Setup25
- WAN Interface Setup27
- Wireless Basic Setup32
- Wireless Security Setup41
9 Operation Mode53
- Setting Operation Mode53
10 Wireless Network54
- Basic Settings54
- Advanced Settings56
- Security57
- Access Control63
- WDS Settings66
- Mesh Settings74
- Wps83
- Operations of AP - AP Being an Enrollee87
- Operations of AP - AP Being a Registrar96
- Wireless Schedule100
11 LAN Interface101
- LAN Interface Setup101
- Changing the LAN IP Address and Subnet Mask103
- Show Client105
12 WAN Interface106
- Configuring Static IP Connection109
- Configuring DHCP Client Connection111
- Configuring Pppoe Connection113
- Configuring PPTP Connection115
- Configuring L2TP Connection117
- Clone MAC Address118
13 Port Filtering120
- Port Filtering for TCP Port 80121
- Port Filtering for UDP Port 53122
14 IP Filtering123
- IP Filtering for TCP with Specified IP124
- IP Filtering for UDP with Specified IP125
- IP Filtering for both TCP and UDP with Specified IP126
15 MAC Filtering127
- MAC Filtering for Specified MAC Address128
16 Port Forwarding129
- Port Forwarding for TCP with Specified IP130
- Port Forwarding for UDP with Specified IP131
17 URL Filtering132
- URL Filtering for Specified URL Address133
18 Dmz135
- DMZ Host IP Address135
19 Vlan136
20 Qos138
21 Status138
22 Statistics139
23 Dynamic DNS140
- Configure Dyndns142
- Configure TZO143
24 Time Zone Setting144
- SNTP Server and SNTP Client Configuration Settings144
25 Denial-Of-Service145
26 Log147
- System Log147
27 Firmware Update149
- About Firmware Versions149
- Manually Updating Firmware149
28 Save/Reload Settings150
- Save Settings to File150
- Load Settings from File152
- Resetting to Defaults153
29 Password155
- Setting Your Username and Password155
30 Logout157
A Configuring Your Computers158
- Configuring Ethernet Pcs158
B IP Addresses, Network Masks, and Subnets159
- IP Addresses159
- Subnet Masks160
C Upnp Control Point Software on Windows XP161
- Upnp Control Point Software on Windows XP with Firewall161

Hamlet 300 - Page 86

Table of Contents