7
Step 5. Turn the wing panel over and deflect the aileron in the
opposite direction and from the opposite side. Apply thin CA
glue to each aileron hinge, making sure that the CA penetrates
into both the aileron and the wing.
Step 6. Using CA remover/debonder and a paper towel, remove
any excess CA glue that may have accumulated on the wing or in
the aileron hinge area.
Step 7. Repeat this process with the other wing panel, securely
hinging the aileron in place.
Step 8. After both ailerons are securely hinged, firmly grasp the
wing and aileron to check that the hinges are securely glued and
cannot be pulled out. Do this by applying medium pressure,
trying to separate the aileron from the wing. Use caution that you
do not crush the wing structure.
Note: Work the aileron up and down several times to “work
in” the hinges and check for proper movement.
CONTINUED
Section 1. Hinging the Ailerons
To Next Page
Loading...
