26
3 Safety Rules
1) Only trained and authorized operator shall
be permitted to operate the forklift.
2) Operator must wear helmet, working
shoes and uniform.
3) Never take people.
4) No transporting with a raised load.
5) It is not allowed to reconfigure the truck
without manufacturer’s permission.
6) Do not work in flammable and
combustible environment.
7) Check the oil, fluid leakage, deformation,
flexibility in certain time. If neglected,
service life of forklift will be shortened and
in serious condition there will be accident.
– Make sure change the “safety parts”
during the schedule maintenance.
– Wipe off the oil, grease or water on the
soleplate, foot pedal and control stick.
– No smoking or any spark, smoke near the
battery when checking.
– Be careful of scald when checking motor
and controller.
8) The controller equips with energy
accumulator, do not touch between B+
and B- to avoid electric injury. If you need
check or clean the controller, connect
load(like contactor coil or horn) between
controller B+ and B- to discharge the
controller capacity.
9) Whenever you find the forklift abnormal,
stop the truck, put on the DANGEROUS
or FAULT sign to the truck, remove the
key, and report to the managing person.
Only after eliminating the fault can you
use the truck.
– If there occurs to fault, battery electrolyte,
hydraulic oil or brake fluid leakage when
lifting loads, going up and down the slope,
please organize staff to repair.
10) Internal battery may generate explosive
gas, it’s prohibited any flame close the
To Next Page
Loading...
