Hanna Instruments reserves the right to modify the design, construction or appearance of its products
without advance notice.
Recommendations
for Users
Before using Hanna products, make sure that they are entirely
suitable for your specific application and for the environment in
which they are used. Operation of these instruments may cause
unacceptable interferences to other electronic equipment. Take all
necessary steps to correct such interferences.
During operation, ESD wrist straps should be worn to avoid possible
damage to the electrode by electrostatic discharges.
Any variation introduced by the user to the supplied
equipment may degrade the instruments’ EMC performance.
To avoid electrical shock, do not use these instruments when volt‑
ages at the measurement surface exceed 24 Vac or 60 Vdc.
To avoid damage or burns, do not perform any measurement in
microwave ovens.
The HI98192 is warranted for two years against defects in workmanship and
materials when used for their intended purpose and maintained according to
instructions. Electrodes and probes are warranted for six months. This warranty is
limited to repair or replacement free of charge.
Damage due to accidents, misuse, tampering or lack of prescribed maintenance
is not covered.
If service is required, contact the dealer from whom you purchased the instrument.
If under warranty, report the model number, date of purchase, serial number and
the nature of the problem. If the repair is not covered by the warranty, you will
be notified of the charges incurred. If the instrument is to be returned to Hanna
Instruments, first obtain a Returned Goods Authorization (RGA) number from the
Technical Service department and then send it with shipping costs prepaid. When
shipping any instrument, make sure it is properly packed for complete protection.
Warranty
To Next Page
Loading...
Need help?
General
