4 - Sprayer setup
4.2
Although the sprayer has been applied with a strong and protective surface treatment on steel parts, bolts etc. in the fac-
tory, it is recommended to apply a film of anticorrosion oil (e.g. CASTROL RUSTILLO or SHELL ENSIS FLUID) on all metal
parts in order to avoid chemicals and fertilisers discoloring the enamel. If this is done before the sprayer is put into opera-
tion for the first time, it will always be easy to clean the sprayer and keep the enamel clean for many years. This treatment
should be carried out every time the protection film is washed off
The support leg is stored in retracted position and secured by the
spring loaded linch pin when the sprayer is attached to the tractor.
To retract the support leg: Lift the leg, then pull the linch pin and tilt
up the support leg until the linch pin “clicks” into the upper locking
hole. Then push the crank handle down and turn it so the handle
will rest on the support leg.
Support leg
Before putting the sprayer into operation
To Next Page
Loading...