xii Control Panels for X75 Systems Installation and Operation Manual
Preface
Protect the Power Cord
Protect the power cord from being walked on or pinched, particularly at
plugs, convenience receptacles, and the point where they exit from the
apparatus.
Use With Proper Equipment
Use only with a cart, stand, tripod, bracket, or table specified by the
manufacturer or sold with the apparatus. When a cart is used, use caution
when moving the cart/apparatus combination to avoid injury from
tip-over.
Do Not Operate With Suspected Failures
Refer all servicing to qualified service personnel. Servicing is required
when the apparatus has been damaged in any way, such as if the
power-supply cord or plug is damaged, liquid has been spilled or objects
have fallen into the apparatus, or the apparatus has been exposed to rain or
moisture, does not operate normally, or has been dropped.
Use Proper Power Source
Do not operate this product from a power source that supplies more than
the specified voltage.
Install Near Socket Outlet
The equipment shall be installed near the socket outlet, and a disconnect
device shall be easily accessible.
ATTENTION:
Observe precautions for handling electrostatic-sensitive devices.
Fuse Replacement
CAUTION: For continued protection against risk of fire, replace only
with the same type of fuse.
ATTENTION: Remplacer uniquement par un fusible de même type et
calibre.
To Next Page
Loading...