16 Control Panels for X75 Systems Installation and Operation Manual
Chapter 2: Operation via Front Panel Controls
Video Input
With control panel video shortcuts, you can select an input (or multiple
inputs) and immediately send it to all video outputs by pressing the
Video In button. The LEDs on the left side of this button indicate which
input is currently selected.
To change the input signal type, follow these steps:
1. Press Video In on the control panel, (or navigate to the Routing
Setup menu and select AllOutSelect).
All available inputs will display on the control panel screen.
2. Use the control panel knob to scroll through the list of input types,
and then press to Enter to select one.
The associated video input LED will become lit. In an example
where the SDI 1 LED is lit, the routing is set automatically such
that the SDI input signal is upconverted and sent to the HD-SDI
output, and to all SDI/Analog outputs.
Figure 2-4. Video Input Control Area
1. Press Video In
2. The LED for the
corresponding
video input type
lights up
The Video
LED lights
during input
selection
To Next Page
Loading...