58 Control Panels for X75 Systems Installation and Operation Manual
Chapter 3: Status and Alarm LEDs
Video Input LEDs
Press the Video In button to select a video source manually and to send
out to all outputs. The LEDs left side of this button indicate which input
is currently selected. The M-Path selection allows any output group to
be assigned to the video input sources. When more than one video
source is selected and mapped to multiple output groups, the M-Path
and corresponding video input source LEDs will light. When the
selected input signal is absent, the LED flashes.
Figure 3-2. Video Input LED Area
Audio Input LEDs
Press the Audio In button to select any one set of audio inputs to be
sent out to all audio multiple output sets. The LEDs to the top, right side
of this button indicate which input is currently selected. When the
selected input signal is absent, the LED flashes.
Figure 3-3. Audio Input LED Area
To Next Page
Loading...