12 Control Panels for X75 Systems Installation and Operation Manual
Chapter 2: Operation via Front Panel Controls
Exploring the Main Menu
There are nine main menu items. Each of them open up into several
layers of submenus and parameter options that you can scroll through
and edit as required. Table 2-1 briefly describes each of the main menu
items.
Setting Non-Numeric Options
The control knob cycles through non-numeric parameter and value
options (such as “Auto, On, Off”).
To set a non-numeric parameter option, follow these general steps:
1. Navigate to the required menu or submenu, and then select a
parameter.
2. Highlight the parameter with the control knob, and then press
Enter.
3. Press Exit to accept your new value and return to the previous
menu or submenu.
Table 2-1. Main Menu Items
Menu Name Menu Description
Video Setup Configures and controls the video settings
Audio Setup Configures and controls the unit’s audio settings
Reference Setup Configures and controls the genlock and other
reference settings
Video/Audio Timing Selects the options for video-to-audio delay and
audio channel swapping
High End Streaming Configures the streaming network settings and bit
rate
System Config Configures settings of the initial setup parameters
Global Frame Rate Sets the unit’s frame rate per second
SD Operating Standard Provides a read-only view of the selected or
detected SD-SDI operating standard
HD Output Standard Provides a read-only view of the selected HD-SDI
operating standard
To Next Page
Loading...