6 Control Panels for X75 Systems Installation and Operation Manual
Chapter 1: Introduction and Installation
Figure 1-3. Removing the Bottom Front Panel Screws
5. Pull the blank front panel from the unit.
6. Carefully insert the new front panel, ensuring that you align the
connector pins located behind the VFD.
7. Replace the screws on the bottom and top of the unit.
8. Reconnect all cabling, and restore power.
X75-RCP
The X75-RCP Remote Control Panel is a 1RU unit that is secured to a
rack using standard front mounting ears located on the frame chassis.
The power supply has a universal input of 100-240 VAC~ 50/60 Hz,
and maximum power consumption of 6 watts. There is no voltage
selector switch.
To install an X75-RCP control panel, follow these steps:
1. Secure the control panel to the rack by inserting four mounting
screws (not included).
2. Connect the Ethernet network at the rear of the control panel.
3. Plug in the AC power cord.
Line of seven screws
for removal
To Next Page
Loading...