48 Control Panels for X75 Systems Installation and Operation Manual
Chapter 2: Operation via Front Panel Controls
• Path: Using this feature, you can establish the path of the parameter
that you are currently viewing or adjusting. To obtain the path,
select Path from the options list, and then press Enter. Rotate the
control knob to view the entire path.
• Lock Panel: By selecting and entering this parameter, all card-edge
controls are locked out, preventing accidental changes. To remove
the Lock Panel function, press Ctrl + Exit. If you are using a
DPS-575 or RC-575 to control the X75, press the Default + Exit
buttons on the DPS-575 or RC-575 to remove the locked panel
function.
• Setup: The Setup menu contains a number of parameters that affect
how your display screen operates (see “Display Screen Setup
Parameters” on page 66).
Take
The Take button is used with the Frz Mode button. See page 39 for
more information about the Frz Mode button.
Timing
Using the Timing button, you can access the currently selected video
processing block's phase controls. When multiple input video sources
are selected and processed, pressing the Ctrl and V Proc buttons allows
you to switch between the processing blocks and leads you directly to
the selected timing controls.
The PROC LEDs on the right side of the front panel and the display
shows the currently selected and active block.
• When the Analog processing block is selected, press the Timing
button to access the AVFS & Timing submenu.
• When an SD processing block is selected, press the Timing button
to access the SD1 FS & Timing or SD2 FS & Timing submenus.
• When the HD processing block is selected, press the Timing button
to access the HD Out V-Phase parameter under the Processing
menu, and press the Exit button to access the HD Out H-Phase
control.
The timing controls for the down-converted signal can be adjusted with
the SD-ARC/HD Dn V-Ph and SD-ARC/HD Dn H-Ph controls from
the Video Setup > Processing menu.
To Next Page
Loading...