68 Control Panels for X75 Systems Installation and Operation Manual
Appendix B: Display Screen and Device Setup Parameters
Device Setup Parameters
Additional Setup parameters affect how the control panel functions on
the network. Local and remote control panels have slightly different
paths for accessing these parameters, and some of the parameters shown
on the local control panel Setup menu are not related to control
functions. Only those parameters related to network control are
described in the following pages.
To access the device Setup parameters on a frame-mounted local
control panel, follow these steps:
1. In the Main Menu, select System Config.
2. Select Setup.
3. Select the parameter you wish to view or change.
To access the Device Setup parameters on an X75-RCP Remote
Control Panel, follow these steps:
1. Press the Remote button.
2. Select Device Setup and then press Enter.
3. Select the parameter you wish to view or change.
On an X75-RCP, the Device Setup parameters can also be accessed
from the Remote Units menu when the remote control panel is first
powered up.
Machine Name
This option makes it possible to give a custom name to the unit, instead
of the normal IP address. The new machine name is visible on other
control panels in the network; however, the Machine Name parameter
is only available on local control panels.
To Next Page
Loading...
Need help?
General
