54 Control Panels for X75 Systems Installation and Operation Manual
Chapter 3: Status and Alarm LEDs
Location
The Status and Alarm LEDs are located together in the center of the
panels, as shown in Figure 3-1.
Figure 3-1. Status LED Area
Genlock Status LED
The Genlock LED indicates the current status of the external genlock
source.
Table 3-1. Genlock LED Status Definitions
LED Status Operating Condition
On The control panel is configured to Auto Genlock and a
stable genlock source is detected.
Off Genlock is not selected.
Flashing The genlock source is not stable or is missing.
To Next Page
Loading...